Arctic Prowler XT Manual do Operador descarregar pdf (Página 31)

29

The EPS system is battery system pow-

ered; therefore, the battery must be in

good condition and fully charged. Power

delivery and overload protection is pro-

vided by an EPS relay and 30-amp fuse

located under the seat in the Power Dis-

tribution Module (PDM).

The system is self-monitored and will dis-

play a “P0635” malfunction code or Diag-

nostic Trouble Code (DTC) on the LCD

gauge/speedometer should an EPS system

control circuit problem occur. Do not oper-

ate the vehicle with a code displayed.



NOTE: Turn the key switch to the

OFF position then back to the ON

position to reset the malfunction

code. If the code continues to be dis-

played, take the vehicle to an autho-

rized Arctic Cat Dealer for EPS system

servicing before resuming operation.

In the event of electrical power failure,

the EPS system becomes disabled (simi-

lar to an automobile with the engine shut

off). Steering effort increases but steering

control can be maintained.

Speedometer/LCD (XTZ)

EFI034A

1. Odometer/Trip Meter/Condition Dis-

play - Displays odometer (total dis-

tance the vehicle has traveled) or one

of two trip meters used to measure trips

or trip legs corresponding to the func-

tion selected (MPH or km/h). The con-

dition display warns of a system error

condition requiring attention.

The LCD will go blank except the

word VOLT will flash on the LCD

whenever a low voltage (<9 DC volts)

or a high voltage (>16 DC volts) is

detected. When voltage returns to nor-

mal, the gauge must be reset by turning

the ignition key to the OFF position

and then to the ON position.

The letters EFI will flash on the LCD

whenever an EFI system error code is

detected. After 30 seconds, the gauge

will return to normal, but the letters

will continue to flash until the cause of

the malfunction is corrected.

 NOTE: Take the ATV to an autho-

rized Arctic Cat ATV dealer to have

the error corrected and the system

error reset as soon as possible.

2. Fuel Level Indicator - Indicates

approximate amount of gasoline in

the gas tank.

 NOTE: When the bottom segment

flashes, approximately 3.5 L (0.92 U.S.

gal.) of gasoline remains in the tank.

3. Mode Button - Press and release to shift

the gauge through three modes: speed-

ometer/tachometer, distance, and time.

 NOTE: Approximately two seconds

after the Mode Button is released, the

digital gauge will return to full display.

4. Set/Reset Button - Selects or resets

various functions/displays on the dig-

ital gauge.

5. Clock/Engine Hour Meter - The clock

function indicates time in the 12 hour

mode. The hour meter indicates the

total time the ATV has run and cannot

be reset to zero. To set the clock, use

the following procedure.

A. With the ignition switch ON, press

and release the Mode Button (3)

until the Clock/Engine Hour Meter

(1) is displayed; then (if necessary)

press and release the Set/Reset

Button (4) to the clock display.

CAUTION

Never operate this vehicle with a

code indicated on the LCD gauge/

speedometer. This indicates a mal-

function in the EPS system control

circuit and could result in a loss of

power steering assist.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

Comentários a estes Manuais

Sem comentários